Palmer IndustriesDecorative Collar 1" Diameter Two Leg SystemLS21C-MB

This Palmer console leg system with ball fittings and Decorative Collars affords a traditional and timeless feel for today’s finer bathrooms. The unique Palmer ball fitting, with its sharp lines and strong visual presence, provides a classic design element to this model. The decorative collar, repeated at the foot and under the ball fittings, adds an air of refinement and visual interest to this leg.

This 2-leg 1.0” model is designed for a single-sink vanity top. It has decorative collars at each foot and under each ball fitting, with flush caps at the top of each leg and riser. It has rear risers located at the back of the stand for additional support. (This 1.0” model is suggested for use with SMALL VANITIES, typically less than 27” wide.)

• Overall Dimensions: 32" W x 22" D x 32" H
• Size may be cut to fit on site with a chop saw blade or tubing cutter.
• The standard size of this model will accommodate up to a 36” wide x 24” deep vanity top
• Pictured vanity top not included
• All Palmer leg models are included with complete assembly instructions, wall support bracket, all mounting hardware, leveling shims, tile anchors, hex wrench, extra set screws, locating pins, silicone, and polish.
• Standard Crossbar is straight. Curved crossbar is available in two sizes

NOTE: It is the responsibility of the installer to ensure that all sink tops are adequately and securely fastened to the wall, independent of the Palmer System. An aluminum angle bracket is included with each leg system to assist with this attachment, but additional support may be required for extra heavy/wide sink tops -available in options. Plated standard weight wall bracket also available in options.