Sanitop Toilet with Macerator Series Pump 017

Install a Toilet Anywhere You Want.  High Level Of Styling.

Installing a HALF bathroom where you want is often difficult and sometimes even impossible. The main drainpipe is either too far away, or the new bathroom or sink will be lower than the drainpipe, making conventional installation unworkable.

The Sanitop is a system that is used to install a complete bathroom up to 12 feet below the sewer line, or even up to 120 feet away from a soil stack. It can handle the effluent from a toilet and sink.

A normal operating cycle for Sanitop takes about 7-9 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.

A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.

The design of this model consists of vibration absorbers which enable the reduction of operating sound by reducing the transmitted sounds from any location where such resonance transmission could occur. This new design reduces the operating sound of this pump by 10dB.

The Sanitop is simplicity itself to install; there are just four connections.
- The macerator/pump is connected to the spigot of a horizontal rear discharge toilet.
- The toilet tank is connected to the water supply.
- The macerator/pump is connected to the small diameter discharge pipe work.
- The macerator/pump is connected to the electrical supply.