Fill-Flush whirlpool cleaning system is designed to keep your bath clean and hygienic. This system cleans the internal whirlpool plumbing system in less than 5 minutes and with less than 10 gallons of water. The Fill-Flush system allows water to fill the bath through the whirlpool jets. So there is no need for the traditional filling spout; only hot and cold valves.

By their nature, whirlpool plumbing lines have a tendency to harbor soap residue, body oils, dirt and water deposits. Thispatented cleaning system offered exclusively by MTI circulates cleaning solution and fresh water through the internal plumbing system, including the water and air lines, point-massage jets and pump.

Operation is simple. After enjoying a whirlpool bath, drain the tub. Then close the point-massage jets, add cleaning solution, such as MTI's Fresh Wave, in the deck-mounted reservoir, turn on the water and run for 3 minutes. Fresh water and cleaning solution circulate from air line to water line, through the pump, out the suction and down the drain to flush away any residue from the internal plumbing system. (Simple Touch simplifies this further by turning the water flow on at the touch of a button and automatically shutting it off after 3 minutes.) When the process is complete, open the jets. Fresh tap water will then run out of the jets and down the drain, ensuring that the next bath is sparkling clean.

A thorough whirlpool cleaning system is as important as a complete hydrotherapy experience. MTI whirlpools with Fill-Flush help keep your bath sparkling clean and hygienic.

Tub will be plumbed for fill flush, and the valves will be installed on-site in the field. Please mark the location on a diagram of the tub when ordering